• Registered: 2011-05-21
  • Posts: 1

Topic: Harmony G-XT as send effect

I try to find a way to set my harmony G-XT as a send effect. Is there a way (Software or Hardware) to cancel the direct (DRY) signal in the mic way ?
Thanks for your tipps.

Best regards

Jens

  • Registered: 2009-06-19
  • Posts: 1,183

Re: Harmony G-XT as send effect

Hiya Bluelight,

You may find it useful to use the settings for "Mixing with Seperate Mono and Dry Outputs". I've pasted the relevant section below from the manual:

"If you prefer, you can leave the level balancing between your dry voice (Tone active only) and a mono signal of the Harmony, Double and FX to your sound engineer. Ensure the Stereo LED is not lit and that the Harmony knob is set to full right. Connect the outputs to two channels of your audio mixer. The Left (Mono) output will send the “wet” effects and the Right (Dry) output will send your dry voice. These can be adjusted by your sound engineer."

Best wishes,

Joey