• Registered: 2012-01-30
  • Posts: 4

Topic: BLank screen

Hi everyone,
I just purchased a voiceworks unit and made the first crucial mistake. I did not readany of the manuals or guides.

Now because of this, I have made the screen go blank. When I turn on the unit the name of the unit appears then the screen goes blank.

I remember pushing the arrow up and down buttons when the parameter was set to Angle view.
Pleas help, that is the first issue, but if I cannot see the display screen I cannot fiqure out why i dod not have any output

Thank you

Murray

  • From: Victoria, BC
  • Registered: 2011-07-25
  • Posts: 739

Re: BLank screen

Hi murman,

That's something I'd get in touch with support about.

You can contact them via the website. www.tc-helicon.com/support

Cheers,
Craig

Craig @ TC-Helicon's Website

  • Registered: 2012-01-30
  • Posts: 4

Re: BLank screen

Thanks Craig,

I will do that

Murray

  • Jeepers
  • VC Top Contributor
  • Offline
  • Registered: 2012-02-03
  • Posts: 51

Re: BLank screen

You can reset it too - had to do this a couple times at shows when I had a Voiceworks:

-Power on the unit while pressing "ENTER" to enter the system menu.
-Choose "Reset system parameters" press "ENTER" and wait until its done.
-Restart the unit.